Download Free Software Malvern Zetasizer Software Manual

Zetasizer Software, free download. Zetasizer Software: Malvern Instruments Limited. » zetasizer software » malvern instruments download » download software.

• ZETASIZER APS PARTICLE SIZE BASIC GUIDE MOLECULAR SIZE. • Zetasizer APS Basic Guide MAN0494 Issue 1.0 July 2013 English.

• United Kingdom. Tel + [44] (0)1684-892456 Fax + [44] (0)1684-892789 Zetasizer, Malvern and the 'hills' logo are registered trademarks in the UK and/or other countries, and are owned by Malvern Instruments Ltd.

Windows is a registered trademark of Microsoft Corporation. • T able of contents Introduction to this manual. 1-1 Introduction. Masud rana pdf read online. • Table of Contents Zetasizer APS Basic Guide Maintenance. 5-1 Introduction. • Measurement types Zetasizer APS APS2000 Particle size Zetasizer APS + APS5000 Particle size PTC-1000 Note For the Zetasizer serial number double-click the APS icon in the status bar.

Using this manual Read the Health and Safety information in Chapter 3 before using the instrument. • Where to get help Help desk Direct all queries regarding the system to the local Malvern representative initially.

Please quote the following information: Model and serial number of the instrument (located on the rear panel). • Introduction to this manual Chapter 1 Contact the United Kingdom help desk if the local Malvern representative is not available. The direct line to the United Kingdom Helpdesk is +44 (0) 1684 891800. This help line is primarily English speaking.

• Chapter 1 Introduction to this manual Page 1-4 MAN 0494. • Site requirements Introduction This document outlines site requirements for a Zetasizer APS. Ensure all these are met before the instrument is delivered.

Environmental conditions The site must be: Indoors and away from strong light (windows).  Away from heat sources like radiators.

• Chapter 2 Site requirements Space required Provide enough space to allow easy access to all components and connections. This diagram shows the recommended space for a system. Always place the (optional) PTC-1000 to the left of the instrument as the heat output is from the left side of the PTC-1000 and this will prevent hot air being directed towards the APS. • Power cord set requirements Power cord sets must meet the requirements of the country where the product is used. For more information, contact a Malvern representative.

General requirements The following requirements apply to all countries: The power cord must be approved by an acceptable accredited agency respon- . • As with any software, running other applications at the same time may affect the speed of the Zetasizer software.

Minimum recommended specification Contact the Malvern Helpdesk or website for the recommended computer specifi- cation, otherwise consult the Software update notification document supplied on the software CD. • Zetasizer APS instruments are Class 1 laser products and as such, require no special laser safety considerations during normal operation. However, during servicing (which must be performed by a qualified Malvern representative), the servicing engineer may be exposed to class 3b or above laser radiation. We therefore recom- mend that the administrative controls recommendations of the Laser Safety Regu- lations (IEC 60825-1(1993) +A1(1997)+A2(2001) are implemented. • Chapter 2 Site requirements Page 2-6 MAN 0494. • Read and fully understand this section before operating the system. Use of the system in a manner not specified by Malvern Instruments Ltd may impair the protection provided by the system.